Replacement of parts other than the light source may be required in a shorter period. Time varies depending on usage conditions and environments. Measured by acceleration test assuming use of 0.04 - 0.20 mg/m3 of particulate matter. *4 20,000H life for laser light source : Approximate time until brightness decreases 50% from first usage. Specification Description Power supply 100-240 V AC, 5.0-1.8 A, 50/60 Hz: Power consumption 430 W (440 VA) (230 W with LIGHT POWER set to NORMAL/Eco1, 170 W with LIGHT POWER set to Eco2. It isn’t guaranteed in all of the smoky environments. *3 When using the projector in smoky environments such as at events and so on, make sure you replace the air filter every approximately 240 hours of use. Actual data rates, features and performance may vary depending on your computer system, the environment and other factors. *2 Maximum speed and range is achievable when used with same enhanced mode technology. In addition to LCOS Technology, consistent brightness and vertical lens shift, the WUX500 projector is engineered with many other advanced features and functions, including built-in Edge Blending, 4-Point Keystone Correction, Picture by Picture, and Versatile Connectivity and Network Management.
Colour light output measured in accordance with IDMS 15:4 white light output measured in accordance with ISO 21118. Built-in edge blending and registration adjustments seamlessly blend. *1 Colour brightness (colour light output) and white brightness (white light output) will vary depending on usage conditions.
Please note, each manufacturer measures Light Output (Center) independently according to their own methods and therefore it is recommended to refer to Color Light Output measured in accordance with IDMS 15.4 and White Light Output measured in accordance with ISO 21118 when selecting and comparing projectors. There is no official standard for Light Output (Center) measurements and this measurement is made based on the method set by Epson. which will not be 100 correct due to keystone etc BUT as a starting point shows maximum overlay could be 33.75 so to aim at 25-30 seems. *** This light output value is measured at the center of the screen as a reference value which is equivalent to lumens. The brightness of one projector is reduced to match the output of the other.So in theory when they overlap the brightness will match the rest of the screen. Time varies depending on usage conditions and environments. vom Design (via Projection Study tool), ber Programmierungen bis hin zur. ** 20,000H life for laser light source: Approximate time until brightness decreases 50% from first usage.Measured by acceleration test assuming use of 0.04 - 0.20 mg/m3 of particulate matter.